Building the Enclosures Day 5

Based on various factors, a decision has been made to alter the design to a sealed enclosure instead. The enclosure is just too tall at the moment, and the ported ecnlosure f3 is only 4Hz lower than a sealed design. When I consider that the drivers are old and mismatched, it makes sense to opt for a more forgiving design.

Now that the executive decision has been made, the slot port area is removed with the router.

After leveling the enclosure with the belt sander, the top and bottom panels are attached. The panel edges are beveled using the table saw.


Sides/Back

Bracing
1|2|3|4|5|6|7|8|9|10|11|12|13|14|15
Copyright © 2006 Vikash Chauhan. All rights reserved.